Viking F20362J Double Oven User Manual


 
1918
Product Controls
3. Set the Oven Function selector to the desired function –
BAKE, CONVECTION BAKE, OR TRUCONVEC™, etc.
4. Set the temperature control knob to the desired baking
temperature.
5. The automatic time bake program is now set!
NOTE: The display will continue to show the amount of bake time
that was programmed (this will remain until the programmed start
time is reached). You can return the display to clock mode by
pressing the “CLOCK” button – Notice that a small clock will be
displayed in the upper right corner to indicate that a program is in
progress. Switch back to the timer mode by pressing the “BAKE
HOURS” button.
6. When the specified time is reached, the oven will automatically
turn on. It will bake for the programmed amount of time at the
selected temperature.
NOTE: At one minute from the end of the specified bake program,
the oven timer will beep once. At the end of the specified bake
program, the oven will automatically turn off and the timer will
sound a series of three beeps. This will continue until the “START
TIME” button is pressed. The display will then return to displaying
the time.
NOTE: Setting the remaining duration time to :00 will cancel the
Automatic Bake program.
Product Controls
Setting the Min/Sec Timer
The Min/Sec Timer is designed for accurate timing and is ideal for
baking delicate items such as biscuits, cookies, and popovers, and
for precise broiling. The Min/Sec timer can be used at the same
time the Bake Hours or Start Time functions are in use. It can be
used for timing up to 24 hours.
To program the Min/SecTimer
1. Push and release the “min/sec timer” button.
2. Rotate “Set” knob until desired duration of time is displayed.
Timer starts seconds after “Set” knob stops rotating. A tone
indicates the timer has started.
When the timer has one minute remaining, the timer will sound
twice and begin to countdown by seconds. A tone will sound
three times indicating the time is complete and twice every ten
seconds after completion until timer function is cleared.
NOTE: Press any function button to clear a completed cycle or
function.
Clocks and Timers (Digital Display)
Clocks and Timers (Analog Clock)