Filter
Top Products
Troubleshooting
Problem
Possible Cause and/or Remedy
Range will not function.
Range is not connected to electrical power:
Have electrician check power circuit breaker,
wiring, and fuses.
Oven does not operate in
self-clean.
Door is not shut tight enough for automatic
door latch to lock.
Oven is not clean after self-
clean cycle.
Temperature control knob not rotated all the
way past clean until it stops.
Broil does not work.
Temperature control knob is rotated too far
past broil position.
Door will not open.
Oven is still in self-clean mode. If oven is
hot, door latch will release when safe
temperature is reached.
Oven light will not work.
Light bulb is burned out.
Range is not connected to power.
Ignitors will not work.
Circuit is tripped.
Fuse is blown.
Range is not connected to power.
Ignitors sparking but no
flame ignition.
Gas supply valve is in “OFF” position.
Gas supply is interrupted.
Ignitors sparking
continuously after flame
ignition.
Power supply is not grounded.
Power supply polarity is reversed.
Ignitors are wet or dirty.
Burner ignites but flame is
large, distorted, or yellow.
Burner ports are clogged.
Unit is being operated on wrong type of gas.
Air shutters not properly adjusted.
Strong odor and/or smoke
is noticed first few times
oven is used.
This is normal burn off of insulation and
protective oils in oven. This will go away
after using oven a few times.
Oven indicator light on;
oven will not heat
Oven is operating properly. Unit will resume
heating function once it has cooled.
Product Care
Product Care
Door Replacement and Adjustment
1
2
3
4
Reinstall door to range.
Open door completely.
Reinstall hinge trim.
Remove pins from hole in hinges.
5
If the door needs to be adjusted,
loosen hinge trim screws located in
step 2. Adjust the screws located
between the door and kickplate using
a 5/32” hex head allen wrench. After
adjustment, tighten hinge trim screws.
Close door.
42 43