Filter
Top Products
37
4
5/16”
nut
driver
Attach canopy to duct cover/soffit. Seal top of hood to
duct with aluminum tape.
3
To install ventillation kit
refer to ventillation kit
installation instructions.
Run duct work down to bottom edge of duct
cover/soffit and secure in place. Make sure the duct
does not stick down past the cover.
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
1
2
1
3
5
1
2
3
6
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
36
Check framing where cutout will be.
NOTE: 200 lb. limit.
Cut appropriate size hole in ceiling. Either 7” or 10”
depending on your specific unit and ventillator kit.
1
2
Mounting options:
Using duct cover with ceiling mounting
bracket. (Option A - VCIH only)
Using threaded rod for additional support.
(Option B)
Attaching hood directly to soffit or
duct cover.
(Skip to step 3)
A1
Attach duct cover to optional ceiling mounting bracket.
Attach duct cover to ceiling. The ceiling bracket can be
hidden by using a locally supplied trim.
A2
5/16”
nut
driver
B1
Additional support option. Drill holes in all four corners
for threaded rod and run rods from hood to ceiling.
Installation (VCIH Island Hoods) Installation (VCIH Island Hoods)