Filter
Top Products
2322
1
Mea
sur
emen
t
(
A
)
Measurement (A)Mea
sur
emen
t
(
A
)
2
M
e
a
s
u
r
e
m
e
n
t
(
A
)
Measurement (A)
+
1
/
2
”
+1/2”
(
1
.
3
c
m
)
(1.3 cm)
M
e
a
s
u
r
e
m
e
n
t
(
A
)
+
1
/
2
”
(
1
.
3
c
m
)
X
XX
Measure from floor to bottom
of the anti-tip opening located on the back of range.
This will be measurement (A).
Locate anti-tip bracket on rear wall with the top left corner at
measurement (A) plus 1/2” (1.3 cm) from the floor and 3-5/8” (9.2 cm)
from where the right side of range (facing range) is to be located.
1
Note: Refer to electrical and gas
requirements section for proper
installation information.
3
Mark and drill holes where bracket will be located.
4
Attach bracket with
mounting hardware provided.
Connect gas and electrical. Before placing appliance in operation,
always check for gas leaks. This must be performed by your
dealer, a qualified licensed plumber, or gas service company.
Leveling/Adjustments/Alignments (cont.)
Connecting Gas & Electric
WARNING
Tipping hazard.
To reduce the risk of property
damage or personal injury;
install anti-tipping device
provided in accordance with
the installation instructions
in this document. Device
must be engaged properly to
prevent product from tipping
over.
7
Set the high corner of range so that the top of side trim is
3/8” (0.95 cm) above countertop. Level range to high corner.
DANGER
Gas leak hazard.
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
Anti-tip Device Installation
Anti-tip Device Installation
(cont.)
Range
Width
“X”
Dimension
30” 3-5/8” (9.2 cm)
36” 8” (20.3 cm)
48” 5” (12.7 cm)
60” 5” (12.7 cm)
Anti-tip location for each range width.