Filter
Top Products
16
Convertible Display Shelves
Operation
Your wine cellar has two convertible display shelves - one in each of the top
two compartments. To use the display shelf, first remove any wine bottles
stored on the shelf. Next, remove the wine shelf directly above (see Shelf
Removal section). Lift the shelf up, rotate the shelf support up and lock
shelf into place with legs (see illustration below).
Shelf
Support
Wood Facings
Maple wood facings are included with each shelf. These facings may be left
unfinished, finished and sealed, or replaced with other wood to match your
cabinetry. Refer to the wine cellar installation instructions on how to replace
the wood facings.
NOTE: Some finishes may cause undesirable odors. The recommended
procedure is to test a sample in the wine cellar on scrap material before
making permanent changes to wine cellar fronts.
17
Changing Light Tube (top zone)
Operation
To change the light tube, first remove the center grille assembly and turn
the power ON/OFF switch to the OFF position (see the Before Using Your
Wine Cellar section).
Control Panel
1. Remove the four screws from the lamp holder attaching the lamp holder
to the underside of the control panel.
2. Rotate the rear of the lamp holder down and forward then pull the front
tabs that engage into the control out of the control panel.
3. Set the lamp holder and screws to the side.
4. Pull the wires attached to the lamp tube through the hole in the control
panel and disconnect the wires attaching the lamp to the cabinet wire
harness.
5. The lamp tube is to be connected to one white wire and one yellow/red
wire.
6. Place tubes in lamp holder. Feed wires back into control panel and
reassemble in reverse order.
NOTE: Please contact your Viking Range Corporation parts distributor or
dealer to order new light tubes.