Filter
Top Products
- In presentation configuration, a shelf can
hold a maximum of 38 "Traditional"
Bordeaux bottles.
Shelf in sliding version configuration:
To place bottles on a sliding shelf:
- Install the shelf in the selected location.
- Place a wooden locking pin in each of the two
holes located on the right and left of the upper
face approximately 4cm to the rear of the shelf:
when the shelf is slid forwards, these pins stop it
from sliding completely out of the cabinet (See
diagram).
- Start by placing the bottles in the rear recesses
with the base of the bottles towards the back.
- Continue by placing the bottles in the front
recesses facing them in the opposite direction.
-A sliding shelf can only hold one layer of
bottles (maximum of 13 "Traditional"
Bordeaux bottles).
- In order to enjoy optimum accessibility when
setting up the cabinet in a mixed layout, we
recommend that shelves destined to be used as
sliding shelves are located in the middle section
of the cabinet.
Note: If you do not have enough bottles to fill your wine cabinet, it is better
to distribute the load over all of the shelves available to avoid "all on top" or
"all below" type loads. This will allow for a more sturdy cabinet as well as
proper air flow within the cabinet.
Always modify the position of the locking pins when converting a
sliding shelf to a storage or presentation configuration.
Shelf Labels: The shelves all have a label slot in front, designed to receive
the cards delivered with your cabinet, thus helping you to identify the
position of your favorite wines at a glance.
17631 South Susana Road, Rancho Dominguez, California 90221
info@vinotemp.com
8