Vulcan-Hart ECO6D ML-52504 Convection Oven User Manual


 
14
BEFORE FIRST USE
Before using the oven for the first time, it must be "burned in" to release any odors that might result from heating
the new surfaces in the chamber.
1. Using a clean damp cloth, wipe the inside of the oven, including the racks.
2. Close the oven doors, push the On/Off/Oven Cool switch to the ON position, turn the Thermostat to 300°F
(149°C) and allow the oven to cycle for 6 to 8 hours before turning the On/Off/Oven Cool switch OFF.
USING THE ECO4C/ECO6C OVENS
Preheating
1. Turn On/Off/Oven Cool switch to ON position. The Heat light will come on, indicating that power to the
oven is on.
2. Set Thermostat as desired. Refer to COOKING GUIDELINES for suggested temperatures and times for
various products.
3. Prepare product and place in suitable pans. When Ready light comes on, oven has reached desired preheat
temperature.
TWO-SPEED FAN SWITCH
Adjusts air velocity in the oven.
OVEN LAMP SWITCH
Turns lights in the oven on or off.
ON / OFF / OVEN COOL SWITCH
1. ON turns oven control circuits on.
2. OFF turns oven control circuits off.
3. OVEN COOL allows the fan motor to run with the doors ajar to speed oven cooling.
FUSE HOLDERS
Replace fuses with appropriate type described on control panel.
MOISTURE VENT DAMPER
Located to the upper left of the control panel. Open the damper in order to exhaust excess
moisture caused by cooking products with a high moisture content. Close damper when
dry products are being cooked. Settings between OPEN and CLOSED permit selection for the
best performance.