Vulcan-Hart EV60SS Double Oven User Manual


 
7 F-38251 (09-13) REV F
RANGE SERIES
LEGS TO INSTALL
CASTERS TO INSTALL
EV12
4
4
EV24
4
4
EV36
4
4
EV48
8
8
EV60
8
8
EV72
8
8
Installation of Legs/Casters:
1. Carefully tip or lift range to access bottom for leg installation.
2. Align holes in leg/caster mounting plate with pre-drilled holes in bottom of range located in each of
the four corners.
3. Attach mounting plate to bottom of range using four ¼ - 20 x ⅝“ self tapping screws (provided). If
casters are being installed, the locking casters should be mounted on the front.
4. After all legs/casters have been installed, carefully return the range to its upright position.
(For additional leg information, see Leveling section of this manual).
A permanently connected appliance mounted on casters and intended to be secured to the building
structure should adhere to the following:
a. Adequate means must be provided to limit the movement of the appliance without depending on or
transmitting stress to the electrical conduit;
b. The location(s) where restraining means are to be attached to the appliance needs to be on the
outside rear parts of the oven chassis frame of the Range (where the bottom rear heat shield is
bolted to the Range). Use brackets provided as connection points as shown below.
c. The appliance shall be installed using a flexible conduit.
If the range is installed on casters and is moved for any reason, it is recommended that the range be
re-leveled front to back and side to side for even baking.
Restraining Connection Bracket