Filter
Top Products
— 4 —
C24GA SERIES GAS CONVECTION STEAMERS
In Canada:
1. Local codes.
2. CAN/CSA-B149.1 Natural Gas Installation
(latest edition).
3.
CAN/CSA-B149.2 Propane Installation Code
(latest edition), available from the Canadian
Gas Association, 178 Rexdale Blvd.,
Etobicoke, Ontario, Canada M9W 1R3.
LOCATION - GAS STEAMERS
The equipment area must be kept free and
clear of combustible substances.
The recommended clearance for proper
operation is 36" (914 mm) at the front. The
required clearance from combustible or non-
combustible construction is 0" at the sides
and back. The recommended clearance for
service access is 18" (457 mm) at the sides
and 6" (152 mm) from the back.
Make sure there is an adequate supply of air
in the room to replace air taken out by the
ventilating system. If you have any questions,
contact the ventilation system installer.
An exhaust system should be located directly
above the steamer to exhaust steam, flue
exhaust and heat generated by the steamer.
Do not locate the steamer directly over a
drain.
LEVELING AND ANCHORING
Position the steamer in its final installed
location. Place a level on the horizontal area
of the cabinet. Adjust the feet to level the
steamer in both the left-to-right and front-to-
rear directions.
Steamers should be elevated in the front just
enough, about
1
/16" to
1
/8" (2 to 3mm) to give
proper draining. Do this by rotating the
adjustable feet in the proper direction 1 to 1½
turns after leveling. Check drainage in the
steamer compartments by pouring a small
amount of water in the compartment. All the
water should drain.
The rear feet have holes in the flanges for
anchor bolts.