Filter
Top Products
– 11 –
7. Slide the thermostat bulb through the V-slot bracket (Fig. 17). Neatly coil the excess capillary line
without kinking and lay resting in front of the heat shield. Do not pinch the line when reinstalling
the control cover.
NOTE: The bulb should not be exposed and should be completely encased inside the V-slot
bracket. Also take care to insure that the capillary line is not exposed in any way to the burner
flame.
Fig. 17
LEVELING
Unlevel range(s) will create battery installation problems in lining up the manifolding system, and result
in uneven cooked product. Using a carpenter's level, level the range(s) from front to rear and side to
side. With range in its exact location or battery position, adjust leg heights. If installing a battery of
equipment, begin with first unit in battery lineup. Adjust legs by turning feet until all legs are resting on
the floor. If "less legs base" or "toe base" is used, screw the leveling bolt until floor contact is made (Fig. 18).
The casters provided for the ranges are the nonleveling type; therefore, the floor must be reasonably
level or baked products will be uneven and performance will be inconsistent.
Fig. 18