Filter
Top Products
ELECTRIC BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS
F35410 (May 2003) Page 14 of 32
Caution: Do not release wrench while locking pin
is removed or damage to the braising pan may
occur.
A. Slowly release downwards force to remove
spring tension.
B. Rotate lid spring lock nut to the next hole
position then replace locking pin. Continue
until all spring tension is removed, one
position at a time.
C. Remove bolts securing the inside lid
bearing housing to the lid support bracket.
D. Remove lid bearing housing
, lid spring lock
nut and the spring, from spring mandrel.
4. To install:
A. Slide the spring onto the lid spring
mandrel. Insert spring into locator hole on
the lid spring retainer.
B. Slide the lid spring lock nut onto the lid
spring mandrel. Insert spring into locator
hole on the lid spring lock nut.
C. Replace
lid bearing housing.
5. Replace spring on the opposite side.
6. Adjust spring tension as outlined under LID
SPRING TENSION ADJUSTMENT IN
SERVICE PROCEDURES AND
ADJUSTMENTS.