Filter
Top Products
ELECTRIC BRAISING PANS - SERVICE PROCEDURES AND ADJUSTMENTS
F35410 (May 2003)
Page 19 of 32
LEFT SIDE VIEW SHOWN
B. Adjust mounting switch bracket up or
down (as necessary) to obtain the rear
pan dimension of 2.25" to 2.50".
11. Repeat steps 5 thru 9 to check for proper
operation.
LID SWITCH ADJUSTMENT
CAUTION: Lid switch should not allow pan to be
raised if the lid is not opened a minimum of 23"
or damage to the lid may occur.
1. Turn the on/off switch on.
2. Raise the lid to the full open position.
3. Lower the pan to the full down position.
4. Lower the lid to an open height dimension of
23" to 23 1/2" (minimum is 23").
NOTE: For reference, this is approximately 45
angular degrees.
5. The lid switch actuator should make contact
with the trigger (cam) and operate the lid
switch.
6. Operate the "lift control switch" to raise the
pan.
A. If pan raises, the lid switch is functioning
properly.
B. If pan does not raise, continue with
procedure.
7. Remove lid switch cover from lid support
bracket.
8. To adjust:
A. With the lid raised to an open height
dimension of 23" to 23 1/2" (minimum is
23"), loosen lid switch mounting screws
and adjust switch position to operate the
switch. Re-tighten screws.