Filter
Top Products
— 8 —
Once A Day
Thoroughly clean the skillet with warm water and a mild detergent. Rinse thoroughly and wipe dry with
a soft clean cloth.
Stainless Steel
Clean stainless steel surfaces with a damp cloth and polish with a soft dry cloth. To remove
discolorations, use a non-abrasive cleaner.
MAINTENANCE
WARNING: THE TILTING SKILLET AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING,
CLEANING OR SERVICING THE TILTING SKILLET.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH TO INDICATE YOU ARE WORKING ON THE CIRCUIT.
LUBRICATION
Never grease or oil the pivot bearings as this may cause problems with tilting. Bearings are oilite and
never require lubrication.
SERVICE AND PARTS INFORMATION
To obtain service and parts information concerning this tilting skillet, contact the Vulcan-Hart Service
Agency in your area (refer to listing supplied with the skillet), or Vulcan-Hart Company Service
Department at the address or phone number shown on the front cover of this manual.
TROUBLESHOOTING
PROBLEM
Skillet will not operate.
Hot spot on pan bottom.
Skillet difficult to tilt.
POSSIBLE CAUSES
1. Power supply not on.
2. Problem with thermostat or heating
elements. Contact your local Vulcan-Hart
authorized servicer.
Problem with heating element. Contact your
local Vulcan-Hart authorized servicer.
Dirt in oilite bearings causing it to bind. Contact
your local Vulcan-Hart authorized servicer.
FORM 31036 (4-98) PRINTED IN U.S.A.