Filter
Top Products
VPX SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
F25111 (March 2002)
Page 10 of 20
Gasket
1. Open the door.
2. Remove screws from the gasket plate.
3. Pull the gasket plate out from the door housing
and remove the gasket.
4. Position the new gasket on the gasket plate and
reverse the procedure to install. Adjust the door
as outlined under "DOOR SEALING
ADJUSTMENT".
NOTE:
Do not over tighten gasket plate screws as
this will compress the gasket excessively and
interfere with proper door sealing.
Handle
1. Open the door.
2. Remove screws from the top and bottom of the
door.
3. Pull the "inner" door panel out from the door
housing with the gasket plate and gasket still
attached.
4. Remove the nuts and spacers from the handle
screws and remove the handle from the door.
NOTE:
When installing the spacers, the smaller
diameter fits into the slot in the door and the latch
lever must rest on top of the handle latch screw.
5. Reverse procedure to install.