Filter
Top Products
VPX SERIES STEAMER - SERVICE PROCEDURES AND ADJUSTMENTS
F25111 (March 2002)
Page 11 of 20
Latch Assembly
1. Open the door.
2. Remove screws from the top and bottom of the
door.
3. Pull the "inner" door panel out from the door
housing with the gasket plate and gasket still
attached.
4. Remove the screws from the side edge of the
door that secure the latch mechanism and
remove the latch from the door.
NOTE:
When installing, the latch lever must rest on
top of the handle latch screw.
5. Reverse procedure to install.
SERVICE PROCEDURES AND ADJUSTMENTS
WARNING:
CERTAIN PROCEDURES IN THIS SECTION REQUIRE ELECTRICAL TEST OR
MEASUREMENTS WHILE POWER IS APPLIED TO THE MACHINE. EXERCISE EXTREME CAUTION AT ALL
TIMES. IF TEST POINTS ARE NOT EASILY ACCESSIBLE, DISCONNECT POWER, ATTACH TEST
EQUIPMENT AND REAPPLY POWER TO TEST.
DOOR LATCH
ADJUSTMENT
Should the steamer door "jam" and can not be
opened,
DO NOT FORCE OR PRY
the door as
damage will occur.
First, try lifting up on the bottom of the door at the
handle end, to disengage the latch.
If that does not work, remove the right side panel.
The striker that catches on the "door latch" is
located behind the front face of the cooking cavity.
Remove the nut from the striker and this will release
it from the panel.
Once the nut and washer have been removed, door
will open freely.
Remove any burrs on the striker that may cause the
latch to stick.
Reinstall the striker and adjust, so door will not jam.