Filter
Top Products
VCH & VRT SERIES OVENS F-38055 (11-09)
Page 4
ELECTRICAL REQUIREMENTS
ELECTRICAL CODES & STANDARDS:
The oven must be installed in
accordance with:
In the United States of America:
1. State and Local Codes.
2. National Electrical Code, ANSI/
NFPA-70 (latest edition.) Copies
may be obtained from: The
National Fire Protection
Association, 1Batterymarch Park,
Quincy, MA 02269.
1-617-770-3000 www.nfpa.org
In Canada:
1. Local Codes.
2. Canadian Electrical Code, CSA
C22.1 (latest edition.) Copies
may be obtained from: The
Canadian Standard Association.
www.csa.ca
ELECTRICAL CONNECTIONS:
The oven is factory wired for either
110/120 volt single phase or 208/240
volt three phase operation. All 110/120
volt cabinets are equipped with an 8 foot
cord and NEMA 5-15 plug as standard
equipment. All 208/240 volt cabinets
are equipped with an 8 foot cord and
NEMA 6-15 plug. Refer to wiring
diagrams and Specification Chart in the
back of this manual.
The cord and plug supplied is a suitable
durable cord with a proper strain relief.
WARNING:
All 110/120 volt ovens are
equipped with a three-prong plug. It
is imperative that this plug must be
connected into a properly grounded
three-prong receptacle. If the
receptacle is not the proper
grounding type, contact an
electrician. DO NOT REMOVE THE
GROUNDING PRONG FROM THIS
PLUG.
CAUTION:
Verify that the power
source matches the Serial Data Plate
located on the lower back corner of
the oven and the plug configuration
before the connection is made. (Fig.1)
SERIAL DATA PLATE
(Fig. 1)