Filter
Top Products
- 8 -
HEATER ELEMENTS DO NOT COME ON
When the steamer is turned ON and heater elements do not activate, and therefore, the READY light does not
come on, then the contactors may be burned out. If a considerable amount of "chattering" of contactors has been
experienced previously, then the thermostat bulb must be coated with scalant and unable to accurately sense
water temperature in the boiler, and therefore, unable to control the contactors.
1. Replace contactors.
2. Unscrew thermostat bulb, clean off scalants, and screw thermostat bulb back in.
This problem is an indication of inadequate water quality and is not covered under warranty. Have water quality
analyzed and corrected immediately to avoid complete malfunction of the steamer.
COOKING CYCLE DOES NOT OPERATE
Observe that the READY light is on. When the door is opened, the door switch will place the set cooking time
on hold and shut down the heater elements. If cooking, steam generating and set time fail to resume when the
door is closed, then check for a problem with the switch.
1. Close the door. Both the main power switch and READY light should be ON.
2. Set timer. READY light will go off and cooking should begin.