Filter
Top Products
TROUBLE SHOOTING
The following are a list of minor faults with instructions on how to rectify them which should be checked by
the user.
PROBLEM CAUSE ACTION
1. The appliance is not working - power supply failure - check the in-house electric sys-
tem fuse, replace if necessary
2. The appliance does not respond
to entered settings
- Control panel has not been
switched on
- Sensors have been touched for
less than one second
- Several sensors have been
touched at the same time
- Switch it on
- Touch the sensors for a bit longer
- Always touch only one sensor
(except when switching off a hot
plate)
3. The appliance does not respond
and emits a short signal
- Child lock has been activated - Switch off the Child lock
4. The appliance does not respond
and emits a long signal
- Improper operation (improper sen-
sors have been touched or proper
sensors have been touched for too
short a time
- Covered or dirty sensor (sensors)
- Again activate the plate
- Uncover or clean the sensors
5. The whole appliance switches off - No settings have been entered
within 10 seconds from switching
the plate on
- Covered or dirty sensor(s)
- Again switch on the control panel
and immediately enter the settings
- Uncover or clean the sensors
6. One hotplate switches off - Limited time of operation
- Covered or dirty sensor(s)
- Again switch on the hotplate
- Uncover or clean the sensors
7. Residual temperature indicator is
not lighted although the hotplates
are still hot
- power supply failure, the appliance
has been disconnected from the
mains
- the residual temperature indicator
will work again after switching the
control panel on and off.
8. CRACK IN THE CERAMIC
PLATE
DANGER! IMMEDIATELY DISCONNECT THE CERAMIC PLATE FROM
THE MAINS (FUSE) AND CALL THE NEAREST CUSTOMER SERVICE
CENTRE.
9. If the fault still remains Disconnect the ceramic plate from the mains (fuse) and call the nearest
Customer Service Centre.
Important!
You are the person responsible for proper condition and operation of
the appliance in your household. If you call the Service for a fault
which resulted from improper operation, you will be charged with the
costs of the visit even during the period of warranty. We shall not be
held liable for damages caused by a failure to observe this manual.
9