Filter
Top Products
Automatic Power Reduction System
This allows each of the hotplates to be set to oper-
ate at full power for a period of time and then auto-
matically reduce the heating power of the hotplate
to a preset setting. To activate the automatic
power reduction system:
1. Select the hotplate by pressing the respective
hotplate selection sensors (5) and set the heat
ing power to 9 by pressing the plus sensor (8).
2. With the heating power at 9, press the plus sen-
sor (8) again and a dot will be displayed beside
the “9”.
3. Within 10 seconds, set the desired reduced
heating power setting by pressing the minus
sensor (7). The respective hotplate indicator (6)
will alternately flash “A” and the reduced
heating power setting.
4. After the hotplate has heated the pot at full
power and has reduced to the preset power set-
ting, the power setting can be adjusted if
required by pressing the minus (7) or plus (8)
sensors.
Lock Function
The hob has a lock function which when activated
can prevent the hotplate being accidentally
switched on by children, pets etc. It can be operat-
ed when the hob is switched off or in operation. To
activate the lock function, press the lock sensor (9)
until the lock sensor LED is lit. To unlock, press the
lock sensor (9) until the lock sensor LED goes out
and a sound is emitted.
Note: After a power failure the lock function is
activated automatically.
6
OPERATING THE HOB
1. Rear left O 145mm Hotplate
2. Rear right O 180mm Hotplate
3. Front left O 210mm Hotplate
4. Front right O 145mm Hotplate
5. Hotplate Selection Sensor
6. Hotplate Indicators
7. Minus Sensor
8. Plus Sensor
9. Lock Sensor with LED
10. Main Sensor
4
3
1
2
5
65
7
8
9
10
Switching The Hob On
To turn on the hob press the main sensor (10) and
the hotplate indicators (6) will all show “0”. Select
the desired hotplate to be turned on by pressing
the respective hotplate selection sensor (5) and
then setting the desired heating power using the
plus (8) and minus (7) sensors, up to a maximum
setting of nine.
Note: If a hotplate is not activated within 10 sec-
onds of turning on the hob, the hob will automati-
cally switch off.
Switching The Hob Off
All the hotplates can be turned off simultaneously
by pressing the main sensor (10) or the hotplates
can be turned off individually by pressing the
respective hotplate selector sensor (5) and setting
the heating power to “0” using the minus sensor
(7). The letter “H” will be displayed in the respec-
tive hotplate indicators (6) until the hotplate has
cooled.
Limited Time Of Operation
To increase its reliability the plate
is provided with an operation time
limiter for each hotplate. The
maximal times of operation
depend on the last selected heat-
ing power level. Ahotplate switch-
es off automatically if the heating
power has not been changed dur-
ing the specified time (See the
table) and the residual time indica-
tor is lighted. You can however
switch the hob back on and use
the respective hotplates up to the
specified time periods again.
HEATING
POWER LEVEL
MAXIMAL TIME
OF OPERATION
IN HOURS
1 10
2 10
3 5
4 4
5 3
6 3
7 2
8 2
9 1