West Bend 2 Popcorn Poppers User Manual


 
3
Avoid contact with moving parts.
Never leave appliance unattended when it is plugged into an outlet.
Do not leave appliance plugged in when it is not being used.
“ON/OFF” switch must always be “OFF” when the popping plate is removed.
This popcorn popper will not shut off automatically. To avoid overheating, add corn
and oil before operating.
For household use only.
SAVE THESE INSTRUCTIONS
BEFORE USING FOR THE FIRST TIME
Please check all packaging material carefully before discarding. Many
accessory parts are contained within the packaging material.
See “Cleaning your Stir Crazy
®
2 Corn Popper” section, clean popper thoroughly and
assemble.
USING YOUR STIR CRAZY
®
2 CORN POPPER
Warning: DO NOT USE if the glass heating element is cracked or broken.
“ON/OFF” switch must always be “OFF” ( O ) when the popping plate is
removed.
1. Place the base on a dry, level surface, away from any edge. Set the popping
plate with stir rod onto the heating base. The handles of the popping plate should
rest snugly over the handles on the heating base and the connector fit completely
over the shaft in the heating base. Make sure that the popping plate with stir rod
is completely seated in the base.
2. Put vegetable oil and corn into the popping plate. Do not substitute butter,
margarine, shortening, or lard for vegetable oil as these will burn or smoke
excessively. Do not add more corn or oil than recommended. Specialty oils
may be used, but some experimentation may be necessary to find the best
popping results and flavor you prefer. Do not use more than 3 tablespoons of any
oil.
Butter Cap
Cover
Popper Base
Butter Well
Popping Plate
with Stir Rod
“ON/OFF” Switch