Filter
Top Products
8
AUTO-BREW
Each press of the PROG/AUTO button will alternatively select between turning Auto-
Brew on and Auto-Brew off. Pressing the PROG/AUTO button when Auto-Brew is
off sets the Auto-Brew to on, the Auto LCD icon flashes, and the display indicates
the programmed Auto-Brew time (steady) in the display for 3 seconds. At the end of
3 seconds the Auto-Brew is set to on and the Auto LCD icon is on steady and the
display goes to clock run mode. Note: If the Auto-Brew is set (on), pressing the
PROG/AUTO button cancels the Auto-Brew and the Auto LCD icon goes off.
When Auto-Brew has been set to on, the PROG/AUTO indicator light and the Auto
LCD icon will be on. The unit will begin brewing at the programmed Drip Coffee
Auto-Brew Time Setting. When the programmed Drip Coffee Auto-Brew time occurs;
the coffeemaker will begin brewing. The PROG/AUTO indicator light and the Auto
LCD icon will be off. The ON/OFF indicator light and the Brew LCD icon will be on.
The Brew LCD icon will go off upon completion of the brew cycle. The unit will
automatically go into keep warm (if applicable) on completion of the brew cycle and
keep warm will terminate after the programmed number of hours.
ADDITIONAL FEATURES
Aroma Feature: The Aroma feature slows the brew cycle slightly providing a richer
brew if so desired. Each press of the AROMA button will alternatively select
between turning Aroma on and Aroma off. The Aroma feature can only be set when
the coffeemaker is on or the Auto-brew is programmed and set. The Aroma feature
and Aroma LCD icon goes on when the AROMA button is pressed. Subsequent
pressing of the AROMA button will turn Aroma feature and Aroma LCD icon off.
Brew Stop Feature: The Brew Stop Feature (carafe in place switch) controls power
to the brew cycle. When the carafe is in place the brew cycle will operate normally.
When the carafe is not in place, the brew cycle will pause and the ON/OFF indicator
light will flash. The brew cycle cannot be started without the carafe in place.
Time to Clean: The Time to Clean LCD icon will display when the coffeemaker
requires decalcification. Perform the decalcification procedure as described in this
manual. The Time to Clean LCD icon will display continuously until reset by
unplugging the coffeemaker
Initial Power Up: Upon initial connection to a power source or the resumption of
power after a power failure the following will occur:
The CLOCK will be flashing.
The default Drip Coffee Auto-Brew Time Setting is 12:00AM.
The default Keep Warm Hours Setting is 2Hr.
The default 24hr Clock Setting is 12:00AM.
The coffeemaker can be started manually without setting the clock (by pressing
ON/OFF button).
The default LCD back-light setting is Auto-off.
The “Time to Clean” default is off.