West Bend QUIKSERVE Coffeemaker User Manual


 
9
LCD Back-Light Setting Function: Upon initial connection to a power source or
the resumption of power after a power failure the default setting is Auto-off. The blue
back-light display will turn off after approximately one minute if the unit is off. The
blue back-light display will remain on while the coffeemaker is brewing or in keep
warm mode. The blue back-light display can be set to “Always on” by pressing the
HOUR and MINUTE buttons at the same time for approximately five seconds.
Performing this function again when “Always on” is set will change the display back
to Auto-off.
CLEANING YOUR DRIP COFFEEMAKER
1. Switch coffeemaker off and unplug from electrical outlet. Allow the entire unit
to cool before cleaning.
2. Remove and discard used grounds and disposable filter from the brew basket.
3. Clean the brew basket, carafe and cover in a solution of warm water and mild
liquid soap. Rinse thoroughly. These parts may also be cleaned in an
automatic dishwasher, top rack only.
4. If there is water left in the water reservoir, empty through the top opening of the
unit by turning upside down over a sink.
5. The exterior of the coffeemaker can be wiped clean with a damp cloth after it
has been unplugged and the base is cooled.
Do not clean the inside of the water reservoir with a cloth or paper towel. This
may leave particles in the chambers that may clog small openings in your
coffeemaker. Rinse with cold water periodically.
Decalcify the Drip Coffeemaker periodically. See the “Decalcifying Your Drip
Coffeemaker” section in this manual.