Filter
Top Products
23
INSTALLING
SAFETY WARNINGS ABOUT INSTALLATION
WARNING
• The cooker MUST be installed and serviced by
a qualified technician.
• A Certificate of Compliance MUST be supplied
to be kept by the customer.
• The packing materials MUST be removed before
you install the cooker.
• You MUST follow the installation instructions in this booklet.
• The surrounding kitchen cabinets MUST be able to
withstand 85°C. Electrolux Products WILL NOT accept
responsibility for damage caused by installation into
kitchen cabinets which cannot withstand 85°C.
• The vents, openings and air spaces MUST NOT
be blocked.
• You MUST NOT pull the cooker by the door handles
or the splashback.
• The cooker MUST be checked every five years.
Locating the cooker
Study the diagrams below to be sure of the dimensions
required to locate the cooker safely.
Note: Make sure that the top of the hotplate surface is
at least 10 mm higher than the level of the benchtops.
TIPS & INFORMATION
Before you cook in your new oven it is important that
the protective oils used in the manufacture of the product
be removed.
• Make sure that the room is well ventilated (to allow
smoke to escape).
• Run the grill on high for 30 minutes, without grill dish.
• Then run the oven on 180°C for 2 hours.
Wiring requirements
The cooker MUST be installed in compliance with
• Wiring connections in AS/NZS 3000 Wiring Rules
• Local regulations, municipal building codes and other
statutory regulations
Data plate • gives information about rating
• is located on the inside panel
of the grill door
Circuit diagram • is located on the back panel
of the control panel
• An all pole disconnect functional switch MUST be
provided near the appliance in an accessible position
(AS/NZS 3000 – Clause 4.7.1).
• Wiring MUST be protected against mechanical failure
(AS/NZS 3000 – Clause 3.9).
• A means of disconnection with a contact separation
of at least 3mm MUST be supplied in the fixed wiring.
Note: To gain access to the terminal block, remove the rear
panel by unscrewing the two assembly screws.
WARNING
When connections are made to a multi-phase 240V supply,
the bridge piece should be removed from between the
active connections.
INSTALLING THE ELECTRIC COOKER
WMAN_540 Upright_Jun11.indd 23 28/06/11 12:07 PM