Westinghouse PEK1350W Cooktop User Manual


 
7
OPERATION
BEFORE OPERATING YOUR APPLIANCE
FOR THE FIRST TIME
TIPS & INFORMATION
SETTING THE TIME
If you have purchased a model fitted with a 3 button
programmable timer, you MUST set the time of day before
you can operate your appliance.
ELECTRONIC CLOCK
After the appliance has been electrically connected
“12.00” will be displayed and the “clock” indicator
will flash.
To set the time of day, press – or +. 5 seconds after
the last change, the “clock” indicator will disappear,
confirming the time has been set.
NOTE: The clock has a 24-hour display.
PREPARING YOUR APPLIANCE FOR THE FIRST TIME
Please remove all internal boxes and bags from
the oven & remove visible labels from surfaces
before operation.
Please wipe out the oven interior prior to operation
with warm soapy water and polish dry with a soft
clean cloth. Do not close the oven door until the
oven is completely dry.
New appliances can have an odour during first
operation. It is recommended to ‘run in’ your oven
before you cook for the first time. Run the oven at
180ºC for 2-4 hours and ensure that the room is
well ventilated.
DO NOT line the oven with foil, it will damage
the enamel.
If your appliance is fitted with a 2-hour “Auto Off”
timer, make sure it is set to the ‘O’ marker for
manual operation.
If your appliance is fitted with solid hotplates,
turn heat setting to high for 3 minutes to fully harden
the coating. When cooled, apply a thin coating of
cooking oil to seal the surface.
FITTING OVEN SHELVES
Ensure shelf orientation is correct (refer picture).
Slide into oven at an angle until raised back of shelf
is past the stop on side runners.
Lower front of shelf and push in until stop is reached.
NOTE: The top ledge is not a shelf position.
NOTE the orientation of the
side and rear features.
WMAN_540 Upright_Jun11.indd 7 28/06/11 12:07 PM