Filter
Top Products
5
Bleeder Button
Use with inside
threaded faucet
only
Push collar down
and slip faucet
adapter onto
faucet
If you specifi ed a countertop installation, your dishwasher
came with a Quick-Connect Faucet Adapter Kit (Part#
DWVCTHK) that includes a fi ll and drain hose assembly that
is compatable with both male (exterior) and female (interior)
threaded faucet connections. If your existing faucet adapter
is not compatable with the Quick-Connect hose assembly
supplied, use the adapter supplied with the Quick Connect
Faucet Adapter Kit:
- If your faucet has a “male” type thread connection, remove
the second rubber washer and use only the standard
washer supplied inside the tap adapter (both 5mm thick).
- If your faucet has a “female” type thread connection, keep
the two rubber washers (both 5 mm) installed inside the
tap adapter.
Installation Location
The minimum height clearance required to install your
dishwasher on a countertop surface with overhead cupboards
is 18” (45.7 cm).
Follow These Steps
1. Screw the faucet adapter onto the faucet, then check for
leaks. (Use plumbing tape to eliminate leaks if necessary.)
2. Connect the open end of the drain hose to the Drain Hose
Connection at the rear of the dishwasher.
3. Connect the water inlet hose to the Water Inlet Connection
(Fig. 9) at the rear of the dishwasher.
4. Attach the Quick-Connect Faucet Adapter by pulling down
on the outer collar while pushing upwards on the faucet
adapter. When the Quick Connect snaps onto the adapter,
release the outer collar and it will lock into place. Check for
a correct fi t.
5. Slowly open the hot water line. Examine all hose
connections for water leaks. Immediately close the water
supply and repair the hose connections if leaks are found.
6. If you are unable to successfully complete the countertop
installation yourself, please call our Service Headquarters
toll-free: 1-800-356-0766.
INSTALLATION INSTRUCTIONS
COUNTERTOP INSTALLATION
vesta_dwv303b.indd Sec1:5 11/9/2005 8:32:29 AM