Filter
Top Products
6
CAUTION
!
!
WARNING
!
!
WARNING
!
!
When the cycle is complete, always relieve water pressure
from the inlet hose:
- Close the HOT water supply at the stopcock.
- Disconnect the Power Supply Cord
For Built-In Installations
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found. Remove and clean the fi lters and
the water valves. Replace the inlet hose as needed to reduce
the risk of hose failure.
For Countertop Installations
Release water pressure from inside the fi ll hose by pressing
the “red” Bleeder Button on the Quick Connect Assembly un-
til the water fl ow stops. Then, disconnect the Quick Connect
Hose Assembly from the faucet by pulling down on the outer
collar.
When the dishwasher is not in use, place/store the hose on a
hanger hose bracket or similar hanging device.
Appliances that are to be discarded must be made
unusable. Before discarding, remove the door to the
washing compartment.
DO NOT LET CHILDREN DISCONNECT THE
DISHWASHER QUICK-CONNECT HOSE
ASSEMBLY. Close supervision of children is
always important around appliances.
To relieve water pressure that’s inside the water
inlet hose, fi rst close the water line (faucet). Then
press the Bleeder Button on the Quick Connect
Assembly until the fl ow of water stops.
BEFORE DISCONNECTING THE QUICK-CON-
NECT ASSEMBLY FROM THE FAUCET, ALWAYS
RELIEVE WATER PRESSURE. Failure to do so
will result in back-pressure overspray. Back-
pressure overspray could cause severe burns
and/or scalding as the temperature of incoming
water could be very hot.
INSTALLATION INSTRUCTIONS
DISCONNECTING YOUR DISHWASHER
vesta_dwv303b.indd Sec1:6 11/9/2005 8:32:29 AM