Whirlpool GB2SHKLLS00 Refrigerator User Manual


 
15
If you choose to turn the refrigerator off before you leave:
1.
Remove all food from the refrigerator.
2.
If your refrigerator has an automatic ice maker:
Turn off the water supply to the ice maker at least one day
ahead of time.
When the last load of ice drops, raise the wire shutoff arm
to the OFF (up) position or move the switch to the OFF
(right) setting.
3.
Depending on your model, turn the Thermostat Control or
Refrigerator Control to OFF. See the Using the Control(s)
section.
4.
Clean refrigerator, wipe it, and dry well.
5.
Tape rubber or wood blocks to the tops of both doors to prop
them open far enough for air to get in. This stops odor and
mold from building up.
Moving
When you are moving your refrigerator to a new home, follow
these steps to prepare it for the move.
1.
If your refrigerator has an automatic ice maker:
Turn off the water supply to the ice maker at least one day
ahead of time.
Disconnect the water line from the back of the
refrigerator.
When the last load of ice drops, raise the wire shutoff arm
to the OFF (up) position or move the switch to the OFF
(right) setting.
2.
Remove all food from the refrigerator and pack all frozen food
in dry ice.
3.
Empty the ice bin.
4.
Depending on your model, turn the Thermostat Control or
Refrigerator Control to OFF. See the Using the Control(s)
section.
5.
Unplug the refrigerator.
6.
Empty water from the defrost pan.
7.
Clean, wipe, and dry thoroughly.
8.
Take out all removable parts, wrap them well, and tape them
together so they dont shift and rattle during the move.
9.
Depending on the model, raise the front of the refrigerator so
it rolls more easily OR screw in the leveling legs so they don't
scrape the floor. See the Door Closing or Leveling Your
Refrigerator section.
10.
Tape the doors shut and the power cord to the refrigerator
cabinet.
When you get to your new home, put everything back and refer to
the Refrigerator Installation section for preparation instructions.
Also, if your refrigerator has an automatic ice maker, remember to
reconnect the water supply to the refrigerator.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Your refrigerator will not operate
Is the power supply cord unplugged
? Plug into a grounded
3 prong outlet.
Has a household fuse or circuit breaker tripped?
Replace
the fuse or reset the circuit.
Is the Refrigerator Control turned to the OFF position?
Refer to the Using the Control(s) section.
Is the refrigerator defrosting?
Recheck to see if the
refrigerator is operating in 30 minutes. Your refrigerator will
regularly run an automatic defrost cycle.
The lights do not work
Is the power supply cord unplugged?
Plug into a grounded
3 prong outlet.
Is a light bulb loose in the socket?
Turn the refrigerator
control to OFF. Disconnect the refrigerator from the electrical
supply. Gently remove the bulb and reinsert. Then reconnect
the refrigerator to the electrical supply and reset the
refrigerator control.
Has a light bulb burned out?
Replace with an appliance
bulb of the same wattage, size, and shape. See the
Changing the Light Bulb(s) section.
There is water in the defrost drain pan
Is the refrigerator defrosting?
The water will evaporate. It is
normal for water to drip into the defrost pan.
Is it more humid than normal?
Expect that the water in the
defrost pan will take longer to evaporate. This is normal when
it is hot or humid.
The motor seems to run too much
Is the room temperature hotter than normal?
Expect the
motor to run longer under warm conditions. At normal room
temperatures, expect your motor to run about 40% to 80% of
the time. Under warmer conditions, expect it to run even
more of the time.
Has a large amount of food just been added to the
refrigerator?
Adding a large amount of food warms the
refrigerator. It is normal for the motor to run longer in order to
cool the refrigerator back down. See the Refrigerator
Features section.
Are the doors opened often?
Expect the motor to run longer
when this occurs. In order to conserve energy, try to get
everything you need out of the refrigerator at once, keep food
organized so it is easy to find, and close the door as soon as
the food is removed.
Is the control set correctly for the surrounding
conditions?
Refer to the Using the Control(s) section.