Whirlpool 3369088 Dishwasher User Manual


 
Water
requirements
The hot water line to the dishwasher
must provide between 15 - 120 PSI
water pressure. The hot waler healer
should be set lo deliver 140°F waler
temperature to the dishwasher for
besl resulls.
Use 310” O.D. copper tubing or l/2”
plastic tubing minimum inlet line.
Dishwasher inlet valve has 3/S
internal pipe thread.
Drain
requfrements
Drain line connection to house
plumbing must be minimum 20”
above floor to prevent siphoning.
Draln hose, supplied, meets
AHAM DW-1 test standards. Cut
l-112’ hole in cabinet wall for drain
hose. Additional drain Ilne, a
minimum of l/2’ I.D. and no longer
than 20 feet can be used if needed.
Numbers
to steps.
Now start . . .
with dishwasher in kitchen.
Disconnect electric supply before
insialling dishwasher.
1
Remove the 4 screws
n
ottoching access panel and
toe panel to dishwasher using a 114”
socket wrench or Phlllrps screwdriver
Remove access panel and toe
ponel.
The dishwasher IS shipped to
. be rnstalled In a 34” cabinet
opening. Meosure height of coblnet
opening from underside of
countertop to floor. Check chart for
that heiaht openno. Put the wheels
in the re-quireb posiion
For addllional helghl.
I Add shims under Ihe wheels
2. Turn fronl levelem leach I”,” adds I,16
in heighll.
Loosen and then turn front levelers
the number of times indicated in
the chart
correspond
Panel B