Whirlpool 3369088 Dishwasher User Manual


 
WI dishwasher backwards on
-
3
Place draln hose in the
n
center of the cabinet
opening. Latch dishwasher door.
Push dishwasher into place. Center
dishwasher in cabinet opening.
Check that front leveling legs
are firmly against the floor. Align
dishwasher door wtih cabinet doors
so that spacing is the same on both
sides.
4
Use pliers to open clamp and
. place over water Inlet hose.
Connect water Inlet hose to water
vatve. Slide clamp over Inlet hose
and water valve.
Check for good fB
Turn on water supply and check for
leaks.
5
Loosen drain hose clamp
. screw. Place clamp over
drain hose. Connect drain hose to
check valve. Tighten draln hose
clamp screw. Check for good fit
Coil and taae extra drain hose
under kitchin sink.
Open dishwasher
H ond remove all shipping
materials. Remove bottom rack.
Place a newspaper or large sheet
of paper over bottom of dishwasher
to brdtect the pump area when- -
securing dishwasher to countertop.
7
Secure dishwasher to
n
countertop with two No.
10 x l/2” Phillips head screws from
parts bag. You MUST secure
dishwasher to keep it from tilting
when door is opened or closed. Da
nOl drop screws in dishwasher tub. If
screws should fall into fhe auma.
pump and motor failure &y c&r.
Remove paper from bottom of
dishwasher.
equally
spaced
Open door approximately 3’ and
check for equal spacing between
inner door and tub sides. If
necessary. loosen screws that fasten
dishwasher to countertop and shift
tub. Tighten screws.
9
.\
Check door for proper
n
operation. Door should close
easily without slamming and open
with its own weight. If necessary.
close door and adjust door spnng by
moving end of spring to a different
hole in base.
11
Plug wiring harness to
. terminal box CHECK
ELECTRICAL REQUIREMENTS. BE SURE
YOU HAVE CORRECT ELECTRICAL
SUPPLY AND RECOMMENDED
GROUNDING METHOD.
12
Toke a few minutes to
. read the Use and Care
Guide to fully understand Your new
dishwasher.
13
Check thot all parts have
. been instolled and no
steps were skipped. Check that you
hove all the tools You started with.
14
Turn on electric supply,
n
Start dishwasher and
allow it to complete a cycle Check
that dishwasher is working properly
and that there are no water leaks.
15
Replace the access
n
panel and toe panel.
16
If color of door is to be
. chanaed or custom
panel installed. Change the panel
now. See back cover for detailed
instructions
10
Plug wiring horness to
n
water valve
Panel C