Whirlpool 3369089 Dishwasher User Manual


 
Now start...
with dishwasher in kitchen.
,’
T
- -
‘64
1~ cabinet wall
Ii
water
SUPPlY
pipe
I
I
I
For additional height:
1. Add shims under the wheels.
2. Turn front levelers (each turn adds 1 /16
in height).
Loosen and then turn front levelers
the number of times indicated in
the chart.
4
Cut a l/2-inch or
larger
hole
I in the cabinet or floor for the
electrical wiring
to pass
through. If
this hole is cut in a wood cabinet,
sand the hole until it is smooth. If the
hole is cut in a metal cabinet, the
hole must be covered by a grommet
(Part
No. 3027971, available from your
dealer or parts supplier.
Install a 3/4-inch U.L.-listed strain relief
to connect the flexible armored or
non-metallic sheathed, copper cable
(with grounding wire) to the fused
disconnect, circuit breaker or junction
box. Run the cable through the hole
in the cabinet opening. The cable
should extend 24” from the back wall.
You may have this type drain connector...
v +5’*+
1
Rough in water line to the
n
dishwasher cabinet opening
using one of the routing methods
shown. Cut l/2-inch hole or larger in
cabinet wall for water line.
. ..or this tvae.
/
Put spring-type drain hose
n
clamp over connector. Push
drain hose onto connector. Use
pliers to open clamp and slide
clamp over drain hose and connec-
tor. Check for good fit.
If screw-type clamp is supplied
instead of spring-type clamp, use a
5/16” nut driver
to t@hten securely.
2
Install a shutoff valve in the
water line where it can be
g easily used.
up
Gz
Remove the 4 screws attach-
9
Flush water line into a bucket
d w to get rid of any particles that
may clog inlet valve. Turn
shutoff
valve to the “OFF” position
u
n
ing the access panel and toe
panel to the dishwasher using a l/4”
hex socket, nut driver or Phillips-head
screwdriver. Remove the access
panel and toe panel.
Floor Damage
Tilt dishwasher backwards on
wheels when moving across floor.
Failure to do so may cause
damage to floor covering.
6
The dishwasher is shipped to
H be installed in 34” cabinet
opening. Measure height of cabinet
opening from underside of counter-
top to floor. Check chart for that
height opening. Put the wheels in
the required position. The dish-
washer should be installed as level as
possible from front to back.
Electrical Shock Hazard
Disconnect electrical power at the
service panel (fuse box or circuit
breaker box).
Failure to so so could result in
serious injury or death.
8
Latch the dishwasher door,
w Push dishwasher into place,
drain hose
shipped inside tub
sliding drain hose through hole cut in
cabinet opening. Check that front
leveling legs are firmly against the
floor. Align dishwasher door with
cabinet doors so that spacing is the
same on both sides.
9
Connect drain hose to an
n
air gap or waste tee using
one
of the recommended or alternate
methods.
, Cut hose connector to fit.
If connecting drain hose to an air
gap or waste tee, cut end of drain
hose as shown.
Secure drain hose with screw-type
hose clamp provided.
Do Not cut drain hose when
connecting to a 7/8” disposer
connector.
Knock out plug from
disposer inlet.
Secure drain hose with
hose clamp provided.
DO NOT cut ribbed section to
shorten drain hose.
Numbers
correspond
to steps.
Panel C