Filter
Top Products
Alternate drain hose connection
methods:
Drain hose to waste tee.
, c~n~e~t~r
Recommended drain hose
connection methods:
Drain hose to air gap to waste tee.
air-gap kit
Tilt dishwasher backwards on wheels
when moving across floor.
Failure to do so may cause damage
to floor covering.
to fit.
waste
tee <
-
screw- or
spring-type
clamp
20”
clearance
w
I
to floor
Entry must be
above trap.
rubber connect0
waste tee
<
If local plumbing codes permit,
dishwasher drain hose may be
connected directly to waste tee’. The
waste tee connection MUST be made
ahead of the trap and a minimum of 20”
above the floor.
mrnrmum
clearance
to floor
8
B Latch dishwasher door. Push
dishwasher into place, sliding drain hose
through hole cut in cabinet opening.
Do not pinch power supply cord or kink
power supply cable between
dishwasher and cabinet.
Check that
front leveling legs are firmly against the
floor. Align dishwasher door with
cabinet doors, so that spacing is the
same on both sides.
above trap.
Drain hose to air gap to disposer.
n
air-gap kit
ny (Part No.
,l-ti-h~O*\
Drain hose to disposer.
A&
It hose
ztor.
9
w Connect drain hose to an air gap
clearance Ill
or waste tee using one of the
recommended or alternate methods.
Cut hose connector to fit, if needed.
to floor
1 yJp+l
J
If local plumbing codes permit.
dishwasher drain hose may be
connected directly to disposer. Most
disposers have 7/8” connectors or special
connectors are available at plumbing
supply houses.
Knock out disposer inlet p
from inlet. If inlet plug
falls inside disposer,
you must remove
inlet plug before
connecting drain
hose. If disposer is
already installed in
sink, you may need t
take out disposer to
remove inlet plug.
Entry must be
I I
above trap.
Install air gap (Par-t No. 300096)’
according to kit instructions. If other
brands of air gaps are used, they
should be checked to make sure they
allow for the same water flow.
Connect the air gap to a waste tee* or
disposer using a rubber connector*.
Most disposer have 7/8” connectors or
special connectors are available at
plumbing supply houses.
If connecting drain hose to an air gap or
waste tee, cut end of drain hose as
shown.
Secure drain hose with screw-type or
spring-type hose clamp (clamp type
varies with models).
Do Not cut drain hose when connecting
to a 7/8” disposer connector.
Knock out
plug from disposer inlet.
Secure drain
hose with hose clamp provided.
DO NOT cut ribbed section to shorten
drain hose.
Knock out disposer inlet
If inlet plug falls inside
disposer, you must
remove inlet plug
before connecting
drain hose. If
disposer is already
installed in sink, you
may need to take
out disposer to remov
inlet plug.
‘All parts are available through your
dealer or local hardware or plumbing
store.
Numbers
correspond
to steps.
Door, access
and toe panels
not shown.
Cut here to cpnnect to
Drain hose
shipped
inside tub.
Panel C