Filter
Top Products
Unit wiring diagram
This model operates at 115 volts except for the cutter
grid circuit which operates at 8.5 volts at 1 amp.
The compressor runs at all times except when the bin
thermostat becomes satisfied and opens up. This de-
energizes the system except for the transformer and
cutter grid.
Under normal operating conditions, when the
evaporator reaches the preset temperature ( + 100 to
-30 F, depending on thickness of ice) the evaporator
thermostat opens, terminating operation of the fan
motor and pump motor. The hot gas solenoid and the
water valve solenoid are energized at this time and re-
main so until the evaporator reaches 38 + 2OF.
r----
------ --------------~
CUBELET CUTTER GRIDS
I-
Y
CUBE
CUTTER GRID
f 11/4”xlX”CubeGrid
Check operation
r/ Start the unit by turning the service switch to
“ON” and opening the line water valve.
fl NOTE: Left is “OFF” - Middle is “ON” - Right
is “CLEAN.” In “CLEAN” position, only the
pump operates.
c/ Check condenser fan to make sure it is
revolving.
/ Water will not enter pump pan until freezing
plate gets cold and machine goes into a harvest
cycle.
fl Check for even water flow over freezing plate.
Unit must be level for proper operation.
r/ Check for desired cube thickness and after 24
hours adjust if necessary. Maximum ice yield will
be obtained with ice thickness at
l/2”
to 5/g”.
fl Replace grill.
7