Whirlpool 800 Series Dishwasher User Manual


 
Changing a cycle setting
(on some models)
You can change a cycle setting anytime
during any cycle.
1. Lii up the door latch to stop the cycle.
2. Turn the Cycle Control Knob cbckwise to
the desired cycle.
3. Check the detergent dispensers. They
must he filled properly for the new cycle.
NOTE: Turning the Cycle Control Knob
can cause the covered section of the
detergent dispenser to open and release
the detergent. Check the covered section
if setting NORMAL WASH or POTS 8
PANS cycle.
4. Close the door firmly until it latches. The
dishwasher starts the new cycle.
Adding an item during a cycle
(on some models)
You can add an additional item to the dish-
washer anytime before the Cycle Control
Knob reaches LIGHT WASH. Items added
after the Cycle Control Knob reaches LIGHT
WASH will only he rii.
1. Lii up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. open the door and add the item.
3. Close the door, but do
not
latch
it.
Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the amount
of moisture in the vent when restarting
a cycle.
4. Cbse the door firmly until it latches. The
dishwasher resumes the cycle.
14