Whirlpool 800 Series Dishwasher User Manual


 
Starting Your Dishwasher
This section tells you how to start or stop your dishwasher. Refer to it for quick reference.
Starting a wash cycle
1. Load the dishwasher. See pages 7-9.
. -
y amt. ftshould turn freely.
gent. See page 10.
agent, if needed. See page 11.
5. Close door firmly until il latches.
6. Run hot water at the sink nearest the
dishwasher until water is hot.
Turn water off. (See page 20.)
7. Select a drying option. (See page 13.)
er
--
El
For models with buttons, the
indicator above the button will
show red when the option has
been selected. For models
with rocker switches, the
switch indites which option has been
selected.
l5l
NOTE: Select AIR DRY for
F’
the RINSE 8 HOLD cycle. For
E’
Series 640 models, push a
Cycle button for the desired
cycle. NORMAL WASH,
LIGHT WASH, and RINSE 8 HOLD
cychs share the same button. The Cycle
Control Knob determines which cycle
operates. For Serifs 630 models, the
HEAT DRY option is automatically
s&dad with the POTS & PANS cycle.
6. Turn the Cycle Control Knob clockwise to
the desired cycle. You will
feel a definite “stop” at each
cycle mark. The dishwasher
automatically starts the cycle
you select.
NOTE: lf the door is latched, you will hear
the cycles start and stop as the control
knob passes each cycle mark. Thii is
normal and does not hurl the dishwasher.
If you prefer, you can set the Cycle
Control Knob with the door unlatched.
Stopping the dishwasher
You can stop your dishwasher anytime
during a cycle. All you have to do is:
l
Open the door slightfy. Wait for any filling
or spraying action to stop before opening
the door all the way. Close the door to
continue the cycle.
OR
l
Turn the Cycle Control Knob slowly
cfockwiie until you hear water draining. Let
the dishwasher drain completely. Then
open the door and turn the Cycle Control
Knob to OFF.
6