Filter
Top Products
Troubleshooting
Before calling for assistance
please check the chart below for problems you can fix. It could
sew you the cost of
a service
call.
Dishwasher Droblems
PROBLEM
CHECK THE FOLLOWING
Dishwasher does
is the door tightly closed and securely latched?
not run or stops
during a cycle
Has the cycle been set correctly? See pages 12-13.
Is the dishwasher set for a delay start? See page 15.
Has a household fuse or circuit breaker blown or tripped?
If the motor stopped because of an overload, it will automatically
reset itself within a few minutes. If it does not start, call for service.
is the water supply turned on?
Dishwasher
runs too long
Dishwasher
will not fill
Water remains
in dishwasher
is the dishwasher wired into a live circuit with the proper voltage?
Cycle times depend on the temperature of the water entering the
dishwasher. Cooler water results in longer cycle times.
Undercounter dishwashers require adequate enclosure for proper
operation. See Installation Instructions for complete information.
is Overfill Protector stuck in “up” position? Overfill Protector shouM
move up and down freely. Press down to release. See page 18.
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If it is clogged, follow the
manufacturer’s cleaning instructions.
Detergent remains
Has the cycle completed?
in covered section
of dispenser
is the detergent fresh and dry without lumps? See page 10.
is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
Dishes not as dry
is the rinse agent dispenser empty? Using a rinse agent greatly
as you expected
improves drying. See page 11.
Do not use AIR DRY option on the next load. See page 14.
Grinding, grating,
Has a hard object entered the POWER CLEANTM module?
crunching, or
The sound should stop when the object is ground up.
buzzing sounds
White residue
appears on front
of access panel
Is too much detergent being used? See page 10 for recommended
amounts of detergent.
Some liquid detergents develop excess foam and residue on panel.
Try a different brand to reduce foaming and eliminate buildup.
is the control panel LOCK OUT feature on? See page 16.
is the door tightly closed and securely latched?
Control panel does
not respond when
pads are pressed
Dishwasher drains
after turning off
indicators
Did you accidentally press the CANCEUDRAIN pad twice? Press
CANCEL/DRAIN pad again to stop draining.
Dishwasher wlii
is the bottom rack in backwards? The rack bumpers must face the
not close
dishwasher door.
i