Filter
Top Products
22
In order t o avoid th at there is more water staying in the i nlet hose,
please close the hyd rant after using.(For the models : no s afet y inlet hose.)
Positioning the Appliance
How to Drain Excess Water From Hoses
If the si nk is 1000 hi gher fr om t he floor, the exces s wa ter i n h oses cannot b e dr ai ned di re ctl y
into the sink. It will be necessary to d rain excess water from hoses into a bowl or suitable
conta iner th at is he ld outside and lower t han the sink.
Water Outlet
Connect the water drain hose. Thedrain hose must be correctly fitted to avoid water leaks.
En sure tha t th e wat er i nl et hose i s no t ki nked or s quashed .
The following things should be checked before starting the dishwasher.
Syphon Connection
Th e was te conn ectio n must be a t a h eight of betw een 50 c m ( minimum ) a nd 10 0 cm (m aximum )
fromthe bottom of the dish. The water drain hose should be fixed by a hose clip.
Start of Dishwasher
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you need a dr ain hose exte nsi on, make sure to use a simila r dra in ho se.
It must be n o lon ge r than 4 metre s; o therwise the cleanin g e ff ect o f t he dishwa she r cou ld b e re duce d.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Connect the cold water supply hose to a t hreaded 3/4(inch) connector a nd make s ure
tha t it is fas tened tigh tly i n place .
If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This p recaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
The water supply to the appliance can also be connected to the household hot water
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case, the w ash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as
described in the section for the connection to the cold wat er line.
Positi on the app lianc e i n the desired location. The bac k sh ould rest ag ain st the wall behind i t, an d the sid es,
along the adj acent c abin ets or wall s. The dis hwa sher is equipp ed w ith wate r supply and drai n ho ses that can
be positioned ei ther to the right or the left sides to facilitate pro per installation.