Filter
Top Products
The dishes were not
loaded correctly .
See notes in " Load ing the Dishwasher Baskets ".
Select a more intens ive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the item s so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a m ild abrasive cleaner t o eliminate th ose marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not e mpty your dishwasher immedi ately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only o n ce t
he dishes are barely war m to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a long washing time.
Water dra in age is more difficult wit h these items.
Cutlery or dishe s of this t ype are n ot s uitable for
washing in the dishwasher.
The programme was
not powerful enough.
Not enough detergent
was dispensed.
Items a re blocking
the path of spray arms.
The filter combination
inthebaseofwash
cabinet is not clean or
is not correctly fitted.
This may cause
the sp ay arm jets
to get blocked.
r
Combination of soft
water and too much
detergent.
Aluminum ut ensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon
Wrong program
has bee n selected
Use of cutlery with
a low-quality coatin g
Error Codes
Tap is not opened, or water intake is restricted,or water pressure
is t oo low.
Malfunctio n of temperat ure sensor or of heating ele ment.
Too mu ch i nlet w ater.
Short circuit or break of temperature sensor
Open circuit or break of temperature sensor
Long er inlet time.
Longer heat ing time,
but not reaching required temperature
Ove rfil led .
Failure of te mperature s ensor
Failure of te mperature s ensor
When some malfunctions co me on, the app li an c e will di s play err or c od es to warn you:
If ov erflow occur s, turn off the main water supp ly before calling a service.
If there is water in the base pan be cause of an overfill or small leak,
the water should be removed befor e r estarting the dis hwash er.
24
Uns a ti s
-factory
was hin g
res u lt
Uns a ti s
-factory
dry i ng
res u lt