Filter
Top Products
Position, Align, and
Level the Dishwasher
Before moving the dishwasher into the opening:
l
Adjust the front levelers so the top of the machine
is l/T below the underside of the countertop
(see Figure 72).
l
Using a hex end wrench or 3/~$ socket, adjust rear
levelers to level the dishwasher from front to back.
l
Cut away carpeting (if necessary) to provide the
dishwasher’s motor adequate clearance for
ventilation. A minimum l/a” gap is required
between motor and floor.
You can now move the dishwasher into the opening
and align it with the cabinets. Use caution when
moving the appliance to prevent damage to floor
coverings and adjacent cabinets.
l
Align the front of the dishwasher as flush as
possible with front of the cabinets.
l
Align the dishwasher so that the amount of space
is the same on each side and the same from top
to bottom.
NOTE: Double check the levelers to make sure
they set firmly against the floor. Leveling is
necessary for proper function of the dishwasher.
You are now ready to proceed with the final drain,
water, and electrical connections.
Drain Hose Routing
Be sure the hose is routed behind the dishwasher
motor and legs (see Figure 73). Place the excess
hose flat on the floor in the dishwasher opening.
NOTE: Be sure there are no sharp bends, kinks,
or twists in the drain hose.
Electrical Shock Hazard
Disconnect electrical power at the fuse box or
circurt breaker box before installing dishwasher.
Make sure that the water supply line, drain
hose, and wiring do not touch any exposed
terminals of the dishwasher wiring.
Failure to follow these mstructions could result
in death or serious Injury
Tip Over Hazard
Do not use dishwasher until completely
installed.
Do not push down on open door.
Doing so can result in serious injury or
Hex End Wrench
or VIS” Socket
Figure 12
Dishwasher Leg
Figure 13
10