Filter
Top Products
If ‘yo111. f;iiicet
spout
has vxxternal threads, screw the
,lti,lrltt:r iron1 [he
Fauce!
Adapter t<lt directly onto
ti?e l;iuci:t. If your fauce: spout has internal threads,
fir-st i:rst;!lI the threaded hushing and rubber washer
front thu iducet Adapter Kit onto the faucet. then
ii>st:;ll the adapter onto the tbushing as shown ~II
F I
qu
r&i ii
RUBBER WASHER
AND THREADED
BUSHING (FOR
FAUCETS WITH
INTERNAL
THREADS)
For other type faucets, see your dealer for special
type adapter kits.
NOTE: If dishwasher is attached to a faucet
equipped with a spray hose attachment,
walc’r pressure is applied to the spray hose.
To prevent possible failure, the spray hose
should be permanently disconnected or rep
placed with a good quality reinforced hose.
3. Electrical Requirements
A 120 Volt, 60 Hz, AC only, 15 Amp (20 Amp
171ilxir1ldl~~~
fused electrical supply is required.
(TII-ne rielay fuse is recommended.) It is recom
nlentle[l tt:,rt a separate circuit serving only this ap-
l)l~;~nce !~e provIdeO. DO NOT
LISC
an extension
coral Se[> Figure 5.
Electrical ground is required on this appliance.
Keconmended Grounding Method
DO NOT, UNDER ANY CIRCUMSTANCES,RE-
MOVE THE POWER SUPPLY CORD GROUND
PRONG.
For your personal safety, this appliance must be
grounded. This appliance is equipped with a power
supply cord having a 3-prong grounding plug. To
minimize possible shock hazard it must be plugged
into a mating 3-prong grounding type wall recep-
tacle, grounded in accordance with the National
Electrical Code and tocat codes and ordinances.
If a mating wall receptacle is not available, it is the
personal responsibility and obligation of the cus-
tomer to have a properly grounding 3-prong watt
receptacle installed by a qualified electrician. See
Figure 6.
m ~-~~%:ING TYPE
WALL RECEPTACLE
3-PRONG
GROUNDING
POWER SUPPLY
CORD