Filter
Top Products
Install Lower Trim
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check that the range is level. See “Level Range.”
5. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, read
the “Range Care” section of the Use and Care Guide.
6. Read the range Use and Care Guide.
7. Slide range into its final location. Check that the flexible
conduit is not bent.
8. Turn power on. Turn on surface cooking elements and oven.
See the Use and Care Guide for specific instruction on range
operation.
If range does not operate, check the following:
■ Household fuse is intact and tight; or circuit breaker has not
tripped.
■ Electrical supply is connected.
■ See “Troubleshooting” in the Use and Care Guide.
When the range has been on for 5 minutes, check for heat. If
range is cold, turn off the range and contact a qualified
technician.
Moving the Range
When moving range, use 2 or more people to lift range onto
cardboard or hardboard to avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
1. Disconnect power.
2. Disconnect wiring.
3. Slide range forward to complete cleaning or maintenance.
4. Check that anti-tip bracket is installed:
■ Look for the anti-tip bracket securely attached to the
support slat.
■ Slide range back so rear range foot is under anti-tip
bracket.
5. Check that range is level.
A. Screws
B. Lower trim piece
B
A
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death
or serious burns to children and adults.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
8101747-60
© 2008. Whirlpool Corporation.
All rights reserved.
1/08
Printed in U.S.A.