Filter
Top Products
To
add a dish after starting
I. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob
has not passed LOW ENERGY WASH.
2. Unlatch the doorto stop the cycle.
3. Open the door and add the dish,
4. Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up.
This helps reduce the amount of moisture
that can come from the vent when restati-
ing the cycle.
5. Latch the door. The dishwasher will start
from where it stopped.
Energy saving tips
You can help save energy if you:
1. Wash full loads. Running a half-filled disn-
washer uses the same amount of electricity
and hot water as a fully loaded machine.
3. Air dry dishes when you don’t need a rapid
drying cycle. Allow longer drying times
[overnight].
2.
4.
5.
6.
7.
Use the LOW ENERGY WASH Cycle whenever
possible. It uses less hot water and energy
than otherwash cycles.
load correctly for best washing results. In-
correct loadrng may cause poor washing
and the need to rewash all or part of the
load.
Don’t pre-rinse normally soiled dishes. Se-
lect the correct cycle for the load and use
the recommended amount of detergent for
good washing results without hand rinsing.
Use your dishwasher during off-peak hours.
Local utilities recommend this to avoid
heavy usage of energy at
CertCIin timEi
of
day.
Kitchen cleanup can be done quickly
and
efficiently through the use of your dishwasher.
Most appliance parts that can fit in the dish-
washer can be cleaned by it. Burned-on soil,
however, should be cleaned by hand.