Filter
Top Products
POWER CLEA4W Washing System
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent against
soiled surfaces of dishes. When a cycle is started, the dishwasher fills with water to about the
ievel of the heating element This water is pumped through the rotating spray arms, through
the POWER CLEAN* Module which removes food particles, and back through the rotating
spray arms. Soiled water is pumped out and replaced with clean water during a cycle-the
number of times depends on the cycle being used
The POWER CLEAN’ Module removes food
particles from the water, stores them, then
washes them down the drain.
Load dishes so soiled surfaces face
pow-
erful spray from rotating arms
Step-sa\ ing preparation for washing
it is not necessary to rinse dishes before
putting them into the dishwasher. Just remove
large pieces, bones, and other hard items The
POWER CLEAN* Module WIII remove food parti-
cles from the water It contains a chopping de-
vice which
NIII
reduce the size of food Items
rf hard Items such as fruit seeds, nuts and egg
shells enter the POWER CLEAN’ Module, you
Iiot water is a must
Hot wate’ dissolves and activates the dish-
washing detergent Hot water dissolves grease
on dishes a?d helps dry glasses spot-free Make
certain loads are washed in hot water [at least
:40 F - 60 ‘;] Two ways to have a reliable hot
water suppmy
I Maintain 140 F ,water supply at central water
heater Tc check water temperature turn on
hot water faucet nearest the dishwasher Let
water rur until it
IS
as hot as possible, then
(check with a candy or meat thermometer If
Quiet operating
tips
To avoid thLmplng and clattering noises during
operation
l
Makesurc llghtwelght ,oad items are secured
in the rack
* Make surf, pot lids and hand!es. pizza pans,
cookie sheets. etc do not touch Intenor walls
A
might hear chopping, grinding, crunching or
buzzing sounds. Those sounds are normal when
hard items enter the module. DO NOT LET
METALLIC ITEMS (I.E. POT HANDLE SCREWS]
GET INTO THE POWER CLEAN* MODULE. THIS
COULD RESULT IN DAMAGE TO THE POWER
CLEAN* MODULE.
the temperature
IS
too low, have a qualified
person raise the watel heater thermostat
setting
2 Use HI-TEMP WASHING Option If water heating
IS
needed, a thermostat will delay the cycle
unttl temperature reaches 145 F (63 C). If
water IS hot enough, the cycle will proceed
with no delay. This lets you turn down your
water heater, if you choose, without cutting
back on hot water needed for good dish-
washing
or interfere with either of the spray arms
rotation
9 Load dishes so they don’t touch one another
NOTE: Keep sink drain plugs inserted during
dishwasher opemtlon to prevent noise trans-
fer through drains.
.lmk