Filter
Top Products
Before you
plug it in
IMPORTANT
Snug IS fine Snug IS fine
but do you war11 It but do you war11 It
that
way?
that
way?
Front Roller
ievelrng
Jse Screwdrrver
to Adjusl
3-prong
grounding type
wall receDtacle \
Refrigerator
Power Cord
Recommended
Grounding Method
Pick the Right Place.
Save steps by putting your refrigerator near the sink and next to a
countertop It should not be near a stove, radiator, water heater or
any source of heat ..rncluding direct sunlight
You can rnstall rt flush against the wall in back. Leave ’ 2 inch
(1 3 cm) clearance against cabinets on each side for ease of instal-
lation. Do you want it in a corner? Leave some room on the wall side
if you want the doors to open wider.
Planning to add the automatic ice maker? Will the refrigerator be
near a cold water pipe7 Some people run the water line through the
floor to the basement Others run it behind the cabinets to the pipes
under the srnk
Make Sure It’s level.
Your refrigerator IS on rollers, the two front ones are adjustable for
leveling.
Remove the base grill to uncover the leveling screws With a
screwdrrver, turn each screw to the rrght to raise the front Turn them
to the left to !ower the front. (If you have someone tilt the top of the
refrigerator back while turning, it will be easier.]
Keep adlustIng one or the other until the refrigerator won’t rock
Then rarse or lower both by the same number of turns until the refrig-
erator IS level [use a level to check thts). If you don’t have a level, the
refrigerator
will
be about right when you canopen the refrigerator
door part way and It
will
stay where you put it,
Peel Off the labels.
Remove the Consumer Buy Guide label and other inside labels
before using the refrigerator Any glue left can be taken off with
rubbing alcohol.
Do not remove the Tech Sheet fastened behind the base grill.
Wash It.
To clean your refrigerator before using it, check the washing in-
structrons in this booklet
Plug It In.
A120 Volt,
60
Hz., AC only, 15 or
20
ampere fused electrical supply IS
required lt IS recommended that a separate circuit serving only this
appliance be provided.
DO not use an extension cord. Use a receptacle which cannot be
turned off with a switch or pull chain.