Filter
Top Products
Using your refrigerator
Power Saving Control
Temperature Control Dial -Set on 3
Air Outlet
Air Control -Set on B
Trlt the Front,
Lrft the Back
Lift the Front,
Then the Back
Push the lab
lo Clear the Cover
Setting the Controls.
The Temperature Control and Air Control dials are on a console
Inside the refrigerator. To startthe refrigerator, turn the TEMP CONTROL
dial to 3 and the AIR CONTROL dial to B. These are normal settings
It takes time for your refrigerator to reach proper storage temper-
atures When you first turn it on, it wtll run continuously until the interror
gets properly cold Before loadrng with food, be sure the refrigerator
has cycled at least once (turned on, turned off, and on again)
Controls
WII
be set about right II your milk or juice
IS as
cold as your
famrly lakes it, and when ice cream is firm
The control console has directrons for raising or lowerrng the tem-
peratures,
if
needed
Power Saving Control.
The Power Saving Control Inside your refrigerator controls electric
heaters These heaters help prevent moisture from forming on the
outsrde of the refrigerator when humidity is high. Use the OFF setting
when humrdtty
IS
low Use ON if moisture forms on the outside of the
refrigerator
Adjusting the Shelves and Meat Pan.
Arrange your refrigerator shelves and meat pan to suit yourself
You can put two shelves together to make one full-width shelf, or put
them on different levels
To remove them, tilt up at the front Then lift up at the back. When
replacing them, keep them tilted, guide the rear hooks Into the slots
in the shelf bracket Lower the front
Before movrng the meat pan Itself. remove the pan by pulling it
out, lifting the front and then pulling out the rest of the way
Removing Non-Adjustable Shelves.
To remove a shelf, lift up the front. Then lift up at the back To
replace it, put the rear notches onto the shelf supports Lower the
front into place
Removing the Crispers and Crisper Covers.
To remove the crispers. slide them out until they stop. Lift the front a
little and slide them the rest of the way out
Each cover
IS
held in place by two pegs at the back and two
notched tabs in the front Press the tabs out of the way to lift the front
Lift the back off the pegs
To put the covers back, replace the center leg Replace each
cover by first fatting the back notches over the pegs Then push the
front down into the notched tabs
The center leg can be made shorter or longer to help level the
crisper covers, if necessary Turn the leg clockwtse to make it longer.
Turn it counter-clockwise to shorten it
A