Filter
Top Products
Using Your Ice Maker
Continued
Setting the controls
1. Select ice thickness. The ice maker has been
pre-set to produce ice approximately l/2”
(13 mm) thick, while operating in a room
temperature of 70°F (21°C).
Operation in different room temperatures may
require readjusting the control toward “THICK”
or “THIN.”
Best operation will be obtained with ice l/2”
(13 mm) to 5/6” (16 mm) thick.
If operating in a warm room (above 90°F
[32”C]) DO NOT set control to maximum
thickness or the unit may malfunction.
2. To start the normal ice making cycle, turn the
Cycle Control Knob to “ON.”
3. To stop ice maker operation, turn Cycle Control
Knob to “OFF.”
The “CLEAN” setting is used whenever solutions
are circulated through the ice maker for cleaning.
Only the water pump operates at this setting. See
“Cleaning the ice maker system” on page 9 for
specific instructions.
Changing the bin door panel
You can easily change the color of the front panel
on the storage bin door. Two colors are available:
Black and White.
To change panel:
1. Open the storage bin door. Remove the two
screws on the top of the door, which hold the
handle.
2. Loosen the screws in both of the side trim
pieces.
3. Remove the handle and the handle insert.