Filter
Top Products
A. CONNECTING ICE MAKER TO FREEZER
PLUG COVER
STEP A3
538533
d
488644
538532
502037
6
I
‘STEP A4
STEP A5 L ’
STEP A8
Al. Put tubing(#627649) in pan of hot tap water to
soften it. This will make it easier to install.
A2. Unplug electrical cord from wall.
A3. With a table knife, pry out all the plastic plugs.
Do not remove Ice Maker connector plug cover.
A4. Insert the 2 brackets (#538532) into the side of
the freezer wall. Attach one clip (#538533) and
screw (#488644) to each of the two brackets.
Leave screw loose. Insert grommet (#502037)
into souare hole on left wall.
AS. Be sure the sliding adapter plug (#627131) is
in the side of the water fill trough as shown.
A6. Remove (#849909) aluminum fill tube from
package. Cut off tube as shown on instructions
for top freezer models packed with tube. Slip
#849909 up over water inlet tube (factory in-
stalled). Make sure that tubes are properly
engaged by looking in oblong hole. Move grom-
met (#835649) upover tube to cover oblong hole.
A7. Remove ICE MAKER CONNECTOR plug cover by
inserting screw driver in slot and rotating driver
to left. Insert Ice Maker connector into the
receptacle under “ICE MAKER CONNECTOR”
plug cover.
A8. Attach the Ice Maker to the side of the freezer
by inserting screw (#488644) through bracket
on bottom front of Ice Maker, and into grommet
(#502037). Rotate clips down and tighten screws.
Be sure that water fill tube (#849909) is in water
fill trough of Ice Maker as shown in A8.
A9. Place ice bucket under Ice Maker