Whirlpool ECKMF-6 Ice Maker User Manual


  Open as PDF
of 6
 
STEP C4
I I
OR ICE MAKER
C4. Slide nut and sleeve (#627018) over tubing.
Push tube insert (#841707) into end of tubrng.
Push end of tubing into water valve. Tighten the
retaining nut, but do not overtighten.
C5. Attach copper tubing and hose connector
(#836200) to water valve. Be sure that rubber
washer is in place, and tighten hose connector.
Anchor to refrigerator with sleeve (#836074),
clamp (#510716) and screw (#488645).
WATER VALVE
TO”’ CONNECTOR
RUBBER WASHER 1
TUBING 1
D.
CONNECTING ICE MAKER
TO WATER SUPPLY
You will need enough G-inch O.D. copper tubing to connect refrigerator to water source.
TYPICAL WAYS TO CONNECT TO WATER SUPPLY
n
B
1
Through floor to
basement cold
water pipe.
Under sink to
cold water pipe.
Through wall to
utility room cold
water pipe.
In crawl space
under home.
CAUTION: Ice Maker tubing should not be installed where temperature may fall below freezing.
 previous