Filter
Top Products
Before using your
refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide Label, tape
and any
inside
labels before using the refrigera-
tor.
To remove any remaining glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing de-
tergent before removing glue as described in
step 1.
DO NOT USE sharp Instruments, rubbing alco-
hol, flammable flulds or abrasive cleaners.
These can damage the material. See “lmpor-
tant Satety Instructions” on page 3.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
2. Clean it...
Clean your refrigerator before using it. See
cleaning instructions on page 9.
3. Plug it in...
J-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERAibR
3-PRONG
POWER CORD
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
sewing only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain.
See Electrical Requirements and
Grounding Instruction Sheet in your Literature
Package.
4. Install properly...
Jr
I I
In
1.
Allow
Y2
inch (1.25 cm) space on each side and
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side closest to the wall so the door can be
opened wider.
3. The refrigerator back can be flush against the
wall.
5. Level refrigerator-freezer...
FRONT ROLLER
II I
VELING SCREW
IGHT TO RAISE;
LEFT TO LOWER
1.
Remove base grille. (See page 8.)
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.
4.
Check with level.
5. Replace base grille. (See page 8.1