Filter
Top Products
Removing and adjusting the freezer shelves...
To remove the shelf:
1.
Liff right side of shelf off supports.
2. Slide shelf out of shelf support holes.
3. Replace in reverse order.
To adjust the shelf:
1.
Remove shelf.
2. Remove supports by sliding upwards.
? track
3. Replace supports on desired level.
4. Replace shelf.
NOTE: The cup shaped supports go in the
I
of the freezer.
Changing the light bulbs...
Electrical Shock Hazard
Before removing a light bulb, either unplug the refrigerator or disconnect the electricity
leading to the refrigerator at the main power supply. Shock
and injury can occur if electricity
remains connected.
To change refrigerator light:
1.
Disconnect refrigerator from power supply.
2. Reach behind the control console to find bulb.
3. Remove bulb.
4. Replace with a 40-watt appliance bulb.
5. Reconnect power supply.
To change freezer light:
1.
Disconnect refrigerator from power supply.
2. Grasp front of light shield.
3. Pull bottom of shield forward until it snaps free.
4. Remove bulb.
GRASP LIGHT SHIELD
PULL BOTTOM FORWA
5. Replace with a 40-watt appliance bulb.
6. Press light shield straight on until it snaps into
place.
7. Reconnect power supply.
Optional automatic ice maker...
If You have the automatic ice maker accessory,
or if You plan to add one later (Part No. ECKMF-90)
there are a few things You will want to know:
l
The ON/OFF lever is a wire signal arm.
Down...for making ice automatically.
UpAo shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
LOWER
SIGNAL
ARM TO
START IT
RAISE
SIGNAL
ARM TO
STOP ICE
l
The dial or lever on the side of the ice maker
changes the size of the cubes.
l
Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You’ll hear ice fall into the bin. Don’t let
these sounds bother You.
. The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
. Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard
the first few batches of ice.
continued on next page