Filter
Top Products
Install properly.. .
Remove sales labels.. .
Remove the Consumer Buy Guide label and other
I.
Allow
‘/2”
(.2 cm] space on each side and at top for
ease of installation.
2. The refrigerator back can be flush against the
WCIII.
3.
If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
e Screwdriver
Right to Raise;
Left to lower
1. Remove base grille (see page 9 ).
2. To raise front, turn each screw to the right
3. To lower front. turn each screw to the left.
4. Check with level.
rnstde labels before using the refrigerator Any glue
left can be taken off with rubbing alcohol.
-..ru~e~c-~-~~---~--~
Clean it.. .
Clean your refrigerator before usrng It. See clean-
ing rnstructrons on page 9
U-grounding plug
t
Refrigerator
Power Cord
Recommended
Grounding Method
A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused
electrical supply is required. It is recommended that
a separate circuit serving only this appliance
be provided.
Do not use an extension cord. Use a receptacle
which cannot be turned off wlth a switch or pull
chain. See individual electrical requirements and
grounding instruction sheet in your literature
4